Chapter 3 – DFI KS230-CD Manual User Manual
Page 20
www.dfi .com
20
Chapter 3 Installing the Devices
Chapter 3
2. Unplug the Serial ATA data cable and remove 4 mounting screws on the system board.
3. Turn the system board to the back side. The Mini PCIe slot is readily accessible.
Mini PCIe slot
Mounting screw
SATA data cable
4. The system board is equipped with 1 Mini PCIe slot. The Mini PCIe slot supports a half length
Mini PCIe card. Note the key on the slot. The key ensures the Mini PCIe card can be plugged
into the slot in one direction only.
5. Grasping the Mini PCIe card by its edges, align the card into the slot at an approximately 30
degrees angle. Apply fi rm even pressure to each end of the card until it slips down into the
slot. The contact fi ngers on the edge of the card will almost completely disappear inside the
slot.
Mini PCIe card