DFI KS230-CD Manual - Manual (Page 18)

www.dfi .com
18
Chapter 3 Installing the Devices
Chapter 3
Installing the CompactFlash Card
1. After removing the system cover, you also need to remove 6 mounting screws on the each
side of the system chassis, mounting screws on the COM port and on the VGA port, and
a spacer and a nut used to secure the DC-in jack. Then, put them in a safe place for later
use.
2. Unplug the Serial ATA data cable and remove 4 mounting screws on the system board.
3. Turn the system board to the back side. The CompactFlash socket is readily accessible.
CompactFlash socket
Mounting screw
SATA data cable
Mounting screw
Mounting screw
Mounting screw
A spacer and a nut