DFI KS230-CD Manual - Manual (Page 25)

www.dfi .com
25
Chapter 4 Hardware Installation
Chapter 4
LVDS Panel Select
SW2
SW2 is used to select the resolution of LVDS panel on the system.
LVDS Panel Select Channel SW2
800x600 6/18 bit Single 1-4 On
1024x768 6/18 bit Single 2-4 On, 1 Off
1024x768 8/24 bit Single 1,3,4 On, 2 Off
1280x768 6/18 bit Single 3-4 On, 1-2 Off
1280x800 6/18 bit Single 1,2,4 On, 3 Off
1280x960 6/18 bit Single 2,4 On, 1,3 Off
1280x1024 8/24 bit Dual 1,4 On, 2,3 Off
1366x768 6/18 bit Single 4 On, 1-3 Off
1366x768 8/24 bit Single 1-3 On, 4 Off
1440x900 8/24 bit Dual 2-3 On, 1,4 Off
1400x1050 8/24 bit Dual 1,3 On, 2,4 Off
1600x900 8/24 bit Dual 3 On, 1,2,4 Off
1680x1050 8/24 bit Dual 1-2 On, 3-4 Off
1600x1200 8/24 bit Dual 2 On, 1,3,4 Off
1920x1080 8/24 bit Dual 1 On, 2-4 Off
1920x1200 8/24 bit Dual 1-4 Off
Note:
The default setting is eDP.
1. 1366x768: N2000 series processor supports eDP only.
2. 1600x1200: N2000 series processor supports DP only.
3. 1920x1080: D2000 series processor supports eDP only.
4. 1920x1200: D2000 series processor supports DP only.