Delta Dore TYPHONE 2 SV - Manual (Page 6)

Dial subscriber
number
Phone
rings
TYPHONE 2SV
connects
Press the control
number required
(e.g. control n˚1) Press
to modify
Select another control
(6 to 7 times)
Hello !
Control n˚1
is turned on
Control n˚1
is turned off
(example)
Select control
1 or 2
or hang up !
1
No code
Code
entry
Pin-in your
4-digit code
Pin-in
secret
code
1 2 3 4
ON/OFF MODE
- When the wrong
code is entered,
a “Wrong code”
message is heard.
The device hangs up after
three unsuccessful attempts
at entering the code.
- TYPHONE 2 SV automatically hangs up after 35 sec. if no button is pressed
- You have up to 3 minutes to complete the sequence
- Press keys only when voice synthesiser is silent.
TIMER MODE
(settings : from 1 to 255 hours)
TYPHONE 2 SV AND ANSWERING MACHINE
ON SHARED LINE
To give priority to TYPHONE 2 SV over the answering machine :
➊ Dial your telephone number, let it ring once, then hang up and wait at least 10 sec.
➋ Dial again within a minute. TYPHONE 2
SV will automatically connect before the
answering machine (phone rings once)
USING THE MANUAL CONTROLS
You can activate controls manually by using the 2 keys on the TYPHONE 2 SV .
Press keys 1 or 2 briefly to turn control 1 or 2 on or off (LED on or off).
OVERRIDING TYPHONE 2 SV
If TYPHONE 2 SV has connected before you can answer a call, press then to override
and take the incoming call.
Dial subscriber
number
Phone
rings
No code
Code
entry
Pin-in your
4-digit code
Press , enter the number
of hours required (e.g. 48hrs),
then press to validate
Select another control
(6 or 7 times)
Hello !
Pin-in
your access
code
Control n˚1
is on timer
Select control
1 or 2
or hang up!
Press the control
number required
(e.g. control n˚1)
Control n˚1
is turned off
(example)
1
1 2 3 4
4 8
6
7
8
9
5
English
- 11 -
Deutsch English
B A B A
A B
F
E
D
GB
A B
F
E
D
GB
A B
F
E
D
GB
P= 2VA - 230 V ~ 50Hz
Jumpers
Jumper on
Jumper off
B A
A B
F
E
D
GB
Français
Español
B A
B A
A B
F
E
D
GB
- 10 -
SETTINGS (DEVICE CONTROL PANEL)
Selecting a language
The product is delivered in “french version”.
To choose another version, it is necessary to separate
the product from its base (see § 3) and turn it over to see
the jumpers as shown on the picture.
Remove the jumper(s) according to your choice.
Using the access code ?
Access to the device may be secured via a code.
This code is printed on the side of the
TYPHONE 2 SV.
Press briefly to enable the code function.
Reverse the NO/NC contact of the output n°2
In order to reverse the NO/NC contact, press the key (about 5 sec.).
LED flashing = contact open, message : Control n°1 is turned on
LED off = contact closed, message : Control n°1 is turned off
2
LED on = code enabled
LED off = code disabled
4
English