Dataprobe iBoot-G2 Operation Manual User Manual
Dataprobe Equipment
This manual is related to the following products:
Table of contents
Document Outline
- 1. Table of Contents
- 2. Important Safety Instructions
- 3. General Description
- 4. Hardware Installation
- 5. Initial Configuration
- 6. Web Browser Operation
- 7. Web Setup
- 7.1. /Device Settings
- 7.2. Expansion Settings
- 7.3. /Network Settings
- Note: All of the TCP/IP Settings require a reboot of the iBoot-G2+, after clicking Save. A Reboot button will appear at the bottom of the page. The new settings will not take effect until the unit is rebooted. Reboot will not affect the power posit...
- 7.4. /Graceful Shutdown
- 7.5. AutoPing
- 7.6. /AutoPing Settings
- Note: All of the AutoPing Settings require a reboot of the iBoot-G2+, after clicking Save. A Reboot button will appear at the bottom of the page. The new settings will not take effect until the unit is rebooted. Reboot will not affect the power pos...
- 7.7. Heartbeat
- 7.8. Heartbeat Settings
- 7.9. Using Heartbeat Monitor
- 7.10. Using the Heartbeat Program
- 7.11. Event Scheduling
- 7.12. User Settings
- 8. iBoot Cloud Service – BETA
- 9. Command Line Interface
- 10. DxP Protocol
- 11. Firmware Upgrades
- 12. Troubleshooting
- 13. Specifications
- 14. Technical Support and Warranty