Initial configuration, Install and run the dmu, Change the ip address – Dataprobe iBoot-G2 Operation Manual User Manual
Page 9
V140506E
iBoot-G2+
Page 9
5. Initial Configuration
The Device Management Utility (DMU), available
online at
provides the easiest means to find and configure
your iBoot-G2+ for use. It can discover all the
iBoots on your network, display the current IP
address of each, and allow setting of any valid IP
address.
Install and Run the DMU
1. Download DMUSetup.exe
2. Run DMUSetup.exe
3. Run the DMU
Note: The IP address can only be set within the
first two minutes of powering up the iBoot. The
DMU will only work with iBoots on the same
physical subnet as the PC.
Once the DMU is run, click on Device | Discover
to display all the iBoots on your network. The
DMU will display the Location Name of the iBoot,
the product ID and Version Number, the current
IP Address, and the MAC Address. Factory
defaulted iBoots will display with the name New
iBoot-G2+ and have the factory default IP
address of 192.168.1.254. If the IP address was
assigned by a DHCP server, no changes to the IP
Address are required.
The IP address field also indicates the port for
web access that is used by the iBoot. The
standard port for web browser control is factory
default Port 80.
Change the IP Address
1. Click on the row containing the iBoot-G2+ to
be set. The row will become highlighted.
2. From the menu select Set | IP Address
3. Enter the new IP Address into the form. Click
OK when done.
4. A confirmation box is displayed. Click OK to
clear the box.
Once the IP Address is set, other all other
operational features of the iBoot-G2+ can be set up. Click on Discover again to refresh the display, highlight
the desired iBoot-G2+ and click on Manage | Launch Browser. Follow the instructions on Page 14 to configure
the iBoot.
The DMU can also be used to return an iBoot-G2+ to its Factory Default condition. This can be used to
recover an iBoot-G2+ with a lost password. Highlight an iBoot-G2+ from the display and select Set | Factory
Defaults. This must also be done within the first two minutes of powering up the iBoot.
DMU Discovers Dataprobe Devices
on Local Network
Enter New IP Address for iBoot
IP Address Successfully Set