Dataprobe iBoot-G2 Operation Manual - Manual (Page 27)

V140506E iBoot-G2+ Page 27
Device Commands Set commands are available to the administrator only
set location <20 char. max>
get location This command is used to set the iBoot- G2’s location ID.
Get returns the current setting
New Boot
set cycle <1-999>
get cycle This command sets the cycle time in seconds
Get returns the current setting 5
set delay <0-999>
get delay This command sets the delay time in seconds
Get returns the current setting 1
set timeout <0-99>
get timeout This command sets the auto logout time in minutes
Get returns the current setting 2
set This command sets the initial state of the outlet when the
iBoot-G2 is initially powered up Last
set upgrade enable Enables or disables the ability to upload new firmware to
the iBoot-G2. no
login Prompts for admin credentials when logged in as user
logout Terminates the session
reboot This command reboots the iBoot-G2.
Graceful Shutdown Commands Set commands are available to the administrator only
Get gsd This command returns all the current settings for
Graceful Shutdown
set gsd This command enables or disables the shutdown delay
process. no
set gsd This command is used to set IP address of the target
system for graceful shutdown.
set gsd This command sets username of the target system
set gsd This command sets the password of the target system
set gsd This command sets the shutdown delay in seconds
set gsd This command sets the reboot delay in seconds