Dataprobe iBoot-G2 Operation Manual - Manual (Page 11)

V140506E iBoot-G2+ Page 11
6. Web Browser Operation
6.1. Password Protection
iBoot-G2+ uses two username/password credential sets, one for normal
power control (User) and one that also provides access to the setup functions
(Admin). This configuration can be changed to require Administrator
credentials at all times or allow unsecured User level control. See section
7.12.
Default Credentials:
Role Username (fixed) Password (settable)
Administrator admin admin
User user user
Open your browser and enter the IP address of iBoot-G2+ into the address bar. If you have changed the IP
address by any of the methods described, enter that address, otherwise, use the default IP address
192.168.1.254
Enter the username and password when prompted. When the proper username/password is received the
Control and Status Page is displayed.
iBoot-G2+ uses an inactivity timer for security. This timeout is user selectable from 0 to 99 minutes. Setting
to zero disables the timeout feature. When there is no activity for the set time in minutes, the user is
automatically logged out and the username and password will need to be entered again for access. This is to
prevent accidental lockout by leaving the user logged in.
As the iBoot-G2+ allows only one Web user logged in at any time, use caution when disabling the
timeout feature, as it is possible to lock out other users by forgetting to logout. Closing the browser
will not log the user out and will lock out web access. If you do become locked out, access the iBoot-
G2+ via Telnet and reboot the unit, or press the reset button (see Section 11)
6.2. Mobile Browser Support
The web pages described below are for screen sizes 700 pixels wide and
greater. The iBoot-G2+ uses a set of mobile browser pages without setup
options. The iBoot-G2+ automatically detects the screen size and redirects
automatically to the mobile pages. There is an option to view the full site from
the mobile pages.