Dataprobe iBoot-G2 Operation Manual - Manual (Page 31)

V140506E iBoot-G2+ Page 31
Heartbeat Commands These commands are only available to the administrator.
get heartbeat This command displays the heartbeat settings
Status Trigger Count
Source: None OK 0
Frequency: 10
Fail Count: 3
Action: None
Outlet: Main
set heartbeat source network> This command sets the source for the heartbeat.
Either USB or Network None
set heartbeat port <1-65535> This command sets the port for the heartbeat protocol.
The heartbeat uses UDP and can be the same port
number as DxP, which is TCP 9100
set heartbeat frequency <1-999> This command is used to set the frequency, in
seconds. How often the iBoot-G2+ expects the
heartbeat 10
set heartbeat failcount <1-999>
This command is used to set the number of
consecutive failures the heartbeat must detect before
the iBoot-G2+ considers the device to be failed. 3
set heartbeat action follow | off-latch | off-follow | cycle> This command is used to set the action that the iBoot-
G2+ will perform when the heartbeat detector triggers. None
set heartbeat cycle <1-999> This command sets the maximum number of power
cycles when the heartbeat triggers 1
set heartbeat outlet This command sets the outlet that the heartbeat will
trigger. Main
User Commands These commands are only available to the administrator.
set user account This command sets whether or not a user account is
used. If only the administrator account is active n
set login required This command sets whether or not a login is required
for user level operation. A login is always required for
admin functions. y
set password
This command is used to set the password of either
the user or administrator. user
admin