Daktronics All Sport 3000 Series - Manual (Page 9)

Introduction 1-1
Section 1: Introduction
This manual is designed to explain the operation of the All Sport
®
3000 Series Control
Console. For questions regarding the safety, installation, operation or service of this system,
please refer to the telephone numbers listed on the cover page of this manual. To fully
understand this manual and the operation of the All Sport 3000 Series console; Daktronics
recommends that you read all general sections of the manual in conjunction with your specific
sport or sports.
1.1 How to Use This Manual
Important Safeguards:
1. Read and understand all instructions before beginning operation.
2. Do not drop the control console or allow it to get wet.
3. Do not let any power cord touch a hot surface or hang over the edge of a
table or counter, which could damage or cut the cord.
4. If an extension cord is necessary, use a polarized cord with a three-prong
plug. Arrange the cord with care – away from foot traffic – so that athletes
or spectators will not trip over it or pull it from its outlet.
5. Always turn off and/or unplug the control equipment when it is not in use.
Never yank the power cord to pull the plug from the outlet. Grasp the plug
and pull it firmly to disconnect.
6. To avoid electrical shock, do not disassemble the control equipment or the
driver modules. Incorrect reassembly can cause electric shock and faulty
operation or permanent damage to the circuits.
The illustration below is an example of a Daktronics drawing label. Drawing
labels are located in the lower right corner of drawings. Each drawing bears a
label in its lower-right corner, and the drawing number is at the bottom of the
label (in the example, 7087-P08A-69945). This manual refers to drawings by
their last set of digits and the letter preceding them. The drawing illustrated
would be referred to as Drawing A-69945.
Figure 1: Daktronics Drawing Label