Daktronics All Sport 3000 Series - Manual (Page 32)

Segment Timer 3-1
Section 3: Segment Timer
Sport Insert LL-2472 (Code 91 used for the Dedicated Segment Timer)
Reference Drawing:
Insert, Segment Timer, A/S 3000 Series .................................. Drawing A-129566
The sport insert drawing is located in Appendix A.
Refer to the information in Section 2: Basic Operation to start the console and use the sport
insert. The insert drawing, A-129566 shows the function for each button for the segment timer
portion of the All Sport 3000 control console. Read Basic Operation carefully to fully
understand the following operation instructions.
If you lose or damage an insert, use a photocopy of the insert until you can order a
replacement.
If you do not know the code number to enter for your scoreboard, refer to Appendix B in this
manual. If you do not know the model number of your scoreboard, refer to the installation and
maintenance manual provided with the scoreboard.
3.1 Segment Timer Information
The Segment Timer is used to time events such as practice sessions. The operation of
the segment timer is determined by 99 segments of preprogrammed length. The
Segment Timer will count down starting at the segment number that is set as First
Segment. When the First Segment is completed, the timer will count the Interval
Time and proceed with the next segment. The timer will continue counting segments
until it counts down to the segment number set as Last Segment. It then will reset to
the segment saved as First Segment and, depending on the Auto Stop At Last Seg
setting, will either begin counting down or wait for the operator to press the
<START> key. To stop the timer after each segment is completed, use the Auto
Stop feature.
The First and Last Segment values can be used to set up specific practice sessions.
For example, the practice session for one sport could be programmed to use
Segments 1-10 while another might use Segments 11-20. Set the First Segment and
Last Segment values to the desired segment numbers for the session, and the
console will count down each of the segments in order, either stopping on the last
segment or looping through included segments again, based on the Auto Stop At
Last Seg setting.
The segment values will be saved when the console is turned off and will be the
same values regardless of the sport that was used to access the Segment Timer.
3.2 Accessing the Segment Timer
To run the Segment Timer for the dedicated segment timer display, enter Code 91
at the Enter Code command.