Daktronics AB-1010 - Manual (Page 16)

Mechanical Installation 2-4
angles (those on the back of the sign and those on the
support structure) and attach with ½
O Grade-5 bolts.
information on routing power and signal.
.
plug g washers that you removed with the eyebolts.
4. Line up the holes on both sets of mounting
5. Refer to Section 3 for
6
Upon completing installation, carefully inspect the sign for any holes that may allow water to seep
into the sign. Seal any openings with silicone. If you remove the eyebolts on the top of the sign,
the holes with bolts and the rubber sealin
2.7 Mounting Optional Light Detectors & Temperature Sensors
If your display has an optional light detector or an optional temperature sensor, refer to Appendix B
r information on installation.
2.8
fo
Prop Rods
Pro
secu
with the cotter pin into the pre-drilled holes in the bottom angle of the display. Secure the rod “T”
rop rods are for safety use. Any deviation from their recommended use may cause serious bodily
p rods are stored in the master display behind the left most lampbank for shipment. The prop rods
re the socket panels open for front access to display electronics. Secure the end of the prop rod
shaped end to the bracket on the rear of the socket panel.
P
injury or damage to the display.