Daktronics AF-3165-34-RGB - Manual (Page 48)

Maintenance and Troubleshooting 4-6
Complete the following steps to remove the controller from the display:
1. Disconnect power from J5
2. Remove all power and signal connections from the board. “Locked” cables
are released by pushing apart the latches, then carefully pulling the cables
from the jack. When replacing the board, it is helpful to have the cables
labeled for easier replacement
3. Remove each of the six screws holding the board in place with a 3/16” nut
driver
4. Follow the previous steps in reverse order to install a new controller board
The rotary switches follow a standard hexadecimal code. The table below shows
several common addresses.
Controller Address Settings
S2
(Upper)
S1
(Lower)
Address
0 0 Test Mode
0 1 1
0 2 2
0 3 3
0 4 4
0 5 5
0 6 6
0 7 7
0 8 8
0 9 9
0 A 10
0 B 11
0 C 12
0 D 13
0 E 14
0 F 15
1 0 16
1 1 17
… … …
F 0 240