D-Link DBT-120 - Manual (Page 56)

57
Q: Dial-up Networking service does not start?
A: The Dial-up Networking service will not start unless a properly configured modem is
attached to the server.
•
Verify that the modem is usable as a local device from the server.
•
In the Bluetooth Configuration Panel, Local Services tab, double-click the
Dial-up Networking service:
o Click the down arrow in the Modem field and select
the modem that will be used to dial out
o Click the OK button
o Click the OK button to close the Bluetooth
Configuration Panel.
Q: How do I determine the Bluetooth Device Address (BDA) of my hardware
device?
A: In the Bluetooth Configuration Panel, on the Hardware tab, in the Devices section,
select the device. In the Device Properties section of the dialog box, the fourth entry,
Device Address, is the BDA of the selected Bluetooth device.
Q: How do I determine the version number of the Bluetooth Specification that
the Host Controller Interface (HCI) complies with?
A: In the Bluetooth Configuration Panel, on the Hardware tab, in the Device Properties
section, the fifth entry provides Bluetooth Specification compliance information for the
Host Controller Interface.
The sixth entry contains the Specification Revision information for the Host Controller
Interface, if appropriate.
Q: How do I determine the version number of the Link Manager Protocol
(LMP)?
A: In the Bluetooth Configuration Panel, on the Hardware tab, in the Device Properties
section, the seventh entry provides Link Manager Protocol version number information.
The eighth entry contains the Link Manager Protocol sub-version number information,
if appropriate.
Q: How do I find information about the Bluetooth hardware attached to my
computer?
A: In the Bluetooth Configuration Panel, select the Hardware tab.
Q: How do I test a Network Access connection?
A: If the client is hardwired to the LAN, unplug the hardwired connection to ensure
that the test checks the wireless connection rather than the hardwired connection.