Daktronics WP-2101 Water Polo LED Scoreboard - Manual (Page 44)

THE CONCEPTS EXPRESSED AND DETAILS SHOWN ON THIS
DRAWING ARE CONFIDENTIAL AND PROPRIETARY. DO NOT
REPRODUCE BY ANY MEANS WITHOUT THE EXPRESS
WRITTEN CONSENT OF DAKTRONICS, INC.
COPYRIGHT 2014 DAKTRONICS, INC.
DAKTRONICS, INC.
AV
DRAWN: DATE:
SHEET JOB NO: REV
LED AQUATICS
INSTALLATION DETAILS; POWER CORD & SIGNAL JACK OPTIONS
MMILLER 10 MAR 14
P 1153 R 03 A
NONE
1166920
00
120VAC POWER CORD AND SIGNAL
JACK OPTION.
240VAC POWER CORD AND SIGNAL
JACK OPTION.
RED
(TIP) BLK
(RING)
SHLD
(SHAFT)
J31
P41, 120VAC POWER
CORD ASSY.
GRN/YEL
WHT
BLK
WIRE NUT NEAR
PWR CORD.
POWER HARNESS
WHT
BLK
CABINET
STRAIN RELIEF
HOOD
SIGNAL JACK & HARNESS
BLK TO LINE 1
WHT TO NEUT.
GRN/YEL
RED TO + BLK TO -
SIGNAL IN
CONNECTIONS IN THE LOAD CENTER
RED
(TIP) BLK
(RING)
SHLD
(SHAFT)
J31
P41, THE CUT 240VAC
POWER CORD BRN
BLU
POWER HARNESS
WHT
BLK
CABINET
STRAIN RELIEF
HOOD
SIGNAL JACK & HARNESS
BLK TO LINE 1
WHT TO NEUT.
GRN/YEL
RED TO + BLK TO -
SIGNAL IN
CONNECTIONS IN THE LOAD CENTER
13"
GRN/YEL
GRN/YEL
WIRE NUT NEAR
PWR CORD.
GRN/YEL
PREPARE THE SIDE OF THE SCBD FOR THE POWER CORD AND SIGNAL JACK:
- LOCATE THE LARGER ETCHED OUTLINE ON THE LEFT SIDE AND BOTTOM AREA OF THE SCBD.
- USE A 1" DRILL BIT AND DRILL OUT THE HOLE. SMOOTH SLIGHTLY IF ANY BURRS OR SHAVINGS ARE SHOWING.
- LOCATE THE SMALLER ETCHED OUTLINE IN THE SAME AREA.
- USE A 3/8" DRILL BIT AND DRILL OUT THAT HOLE. SMOOTH AGAIN AS REQUIRED.