Daktronics Single Section DistaView Outdoor LED Scoreboards Generation IV - Manual (Page 34)

Electrical Installation 4-3
4.2 Power and Signal Connection
Reference Drawings:
Schematic; DistaView OD LED Multi-driver Display .... Drawing A-229706
Driver; GEN IV LC Outdoor LED, 16 Col ..................... Drawing A-285469
Driver; GEN IV LC Outdoor LED, 8 Col ....................... Drawing A-285470
Schematic; XFMR 8 Col, GEN IV, DistaView LED ...... Drawing A-285892
Schematic; XFMR 16 Col, GEN IV, DistaView LED .... Drawing A-286657
Schematic; XFMR 16 Col, GEN IV, Outdoor Driver ... Drawing A-704861
All power and signal wiring terminates at the termination connector TB1, as
illustrated in Drawing A-285892 and A-286657.
To gain access to the termination connector, open the access door and remove the
cover from the enclosure. Refer to the component locations drawings for the access
location for your scoreboard.
Connect power and signal cables at the appropriate locations on the termination
connector TB1, shown in Drawing A-285892, A-286657, A-229706 and A-704861.
Note: The TB1 termination connector has protection variators across the terminals
labeled “signal” to the terminal labeled “ground.” For more information, refer to
Drawing A-285892, A-286657, A-229706, and A-704861..
For signal cable, Daktronics recommends, as a minimum, single-pair, shielded cable,
22 AWG (Daktronics part number W-1077). Two-pair shielded cable (Daktronics
part W-1614) is preferred.
For additional information on signal connection, refer to the All Sport 5000 Series
control console operation manual, ED-11976.