Daktronics Outdoor LED Scoreboards Installation - Manual (Page 31)

Electrical Installation 25
Three-Section Tennis Models
The primary driver and power panel will be located in the top section. Refer to the
component location drawings attached to the product specification sheets listed in
Appendix A for exact driver locations. Open access panels as needed to locate the coiled
bundles of interconnect cable, then route and connect the cables as described below and
shown in Figure 30.
1. Route the interconnect cable labeled P51 coming from the A2 driver in the middle
section up into the top section and connect it to the J51 jack coming from the power
panel and A1 driver.
2. Route one end of the other interconnect cable labeled P51 from the middle section up
into the top section and connect it to the J50 jack coming from the power panel and
A1 driver.
3. Route the other end of the interconnect cable labeled J52 from the middle section down
into the bottom section and connected to the P52 plug coming from the A5 driver.
Figure 29: Re-driving Signal (Rear View)
Figure 30: Power/Signal – TN-2650 & TN-2651