Daktronics HS-200 Horn Start - Manual (Page 9)

Introduction 3
1.5 Specification Label
Power specifications as well as serial and model number information can be found on an ID
label on the bottom of the device, similar to those shown in Figure 2.
When calling Daktronics customer service, please have the model number, serial number,
and the date the device became operational available to ensure the request is serviced as
quickly as possible.
1.6 Using the Horn Start
Before Each Session
Follow these basic steps when preparing for a meet:
1. Connect the fully-charged equipment.
2. Verify that all speakers are working.
3. Test the microphone and set volume levels.
4. Test the start signal to the timing system.
5. Verify the strobe light flashes for a start.
6. Verify the HS-200 Horn Start is set to start tone. Refer to Section 2.
7. Verify that the recall signal is set to ON or OFF as desired. Refer to Section 2.5.
8. Verify that Smart Start is turned ON or OFF as desired. Refer to Section 2.5.
During Competition
Before starting the next heat, verify the start LED is ON-READY
(Figure 3).
After the Competition
1. Remember to recharge the battery for 24 hours (Figure 15).
2. Turn the power switch to OFF.
3. Store the horn start in a clean, dry place.
Figure 2: Specifications Labels
Figure 3: Ready to
Start Light
0A-1056-0234
S/N:
####
(DATE) (REVISION)
HS-200
MODEL: DAKT-401-00
12VAC/DC 20WATTS
1.7 AMPS 50/60 HZ
0A-1056-0126
S/N:
####
(DATE) (REVISION)
REMOTE STROBE
MODEL: DAKT-401-00
12VAC/DC 20WATTS
1.7 AMPS 50/60 HZ