Daktronics HS-200 Horn Start - Manual (Page 16)

System Setup & Operations 10
When the HS-200 system is being powered by the battery and is not plugged into the wall,
the BATTERY FULL and BATTERY LOW LEDs show battery status. The green BATTERY
FULL LED indicates when the battery voltage level is fine for operation. The red BATTERY
LOW LED indicates the battery voltage level is half drained and should be charged soon.
Should the red BATTERY LOW LED begin flashing, the HS-200 unit has 10 minutes of
battery power remaining and will automatically shut down after this period has expired. At
this time, the horn start should be charged immediately. Once the charger is connected to a
120 VAC outlet, the HS-200 system will operate normally.
For information about possible problems with battery charging, please refer to Section 4.
2.5 Horn Start Settings
Enable or Disable Recall On
1. Plug the handheld microphone directly into the MIC jack on the HS-200 horn start.
2. To access the setup mode, turn the power switch to ON. Immediately after the
BATTERY FULL and BATTERY LOW LEDs flash, press the PUSH TO TALK lever
three times.
3. The four LED indicators on the horn start will flash and the speaker will sound a
warbling tone when the Recall On setting is active. If that setting is not active, then
no sound will come from the speaker and the four LED indicators will flash.
4. To change the setting, press the PUSH TO TALK button once. This will enable or
disable the setting.
5. To save the current setting, press and hold the PUSH TO TALK button while
pressing the top button twice. The LEDs should stop flashing. The HS-200 horn start
is now configured for the selected recall setting.
Configure Start Sound
Select between two different swimming tones or a gun shot.
1. Plug the handheld microphone directly into the MIC jack on the HS-200.
2. To access the setup mode, turn the power switch to ON. Immediately after the
BATTERY FULL and BATTERY LOW LEDs flash, press the PUSH TO TALK lever
four times.
3. The four LED indicators on the horn start will flash and the speaker will sound the
current setting. This sound will be either the tone or the gunshot.
4. To change the setting, press the PUSH TO TALK button. Every time that button is
pushed, it will move to a different setting.
5. To save the current setting, press and hold the PUSH TO TALK button while
pressing the top button twice. The LEDs should stop flashing.