Daktronics BA-1518-11 Multi-Section Outdoor LED Scoreboard - Manual (Page 34)

6.5 Ad Panel Mounting
Reference Drawing:
Ad Panel Mounting................................................................................ Drawing A-52187
Drawing A-52187 shows the mounting of advertising or identification panels.
Mount the ad panel or ad panels in the following manner:
1. Use the mounting channel to determine which hole combination to use. Be sure to keep the
bolts as close to the beam as possible.
2. Using the mounting channel as a template, drill 9 /
16
" holes in the upper and lower rear flange
of the ad panel where the supports will go.
3. Place square nuts inside the channel and thread the bolts through.
4. Lift the ad panel into position with the bolts still in place.
5. Place mounting angles over each pair of bolts and secure with lock washers and hex nuts.
6. When the panel is adjusted to the final desired position, tighten the hex nuts firmly.
When mounting ad panels with back sheets, remove the back sheets above and below the upper and
lower rear flanges of the ad panel where the holes have been drilled. Be sure to replace the back
sheets after placing the square nuts inside the channel and threading the bolts through the holes.
6.6 Optional One- or Two-Line Message Center Mounting
Reference Drawing:
Mounting Detail; 2 1 /
2
" Matrix............................................................... Drawing A-115882
Refer to the manual provided with the message center for instructions on how to mount the message
center to the beams using the clamping method. Some retrofit message centers may be mounted
directly to the scoreboard face.
Drawing A-11582 shows the mounting method for a 2
1 /
2
" matrix display.
Mechanical Installation 6-6