Crest Electronics CRE57000 TRAIN ENGINEER REVOLUTION MANUAL - Manual (Page 7)

7
LINK SWITCH
ANTENNA
LINK SWITCH
HEAT SINK
AUXILARY
CONNECTOR
10 PIN SUPPORT
HEADER
12 PIN DCC/RCC
CONTROL HEADER
REMOTE LINK SWITCH
CONNECTOR
REMOTE LINK SWITCH
CONNECTOR
LINK LED
ANTENNA
LINK SWITCH
AUXILARY
CONNECTOR
HEAT SINK
BASIC RECEIVER INSTALLATION FOR PLUG-AND-PLAY DCC/RCC
EQUIPPED LOCOMOTIVES
You will need the following items for installation:
CRE57002 Revolution TE 2.4 Ghz Receiver •
REMOTE Link Switch •
Phillips head screwdriver •
A drill and drill bits to install the remote Link Switch (if desired) •
NOTE: If the locomotive does not have a DCC/RCC compatible main circuit
board, see the custom installation instructions beginning on page 31 of this
manual.
REVOLUTION TE RECEIVER