Compuprint 4247-X03 - Manual (Page 99)

Characters Per Inch (CPI)
This parameter allows the printer to accept or ignore (override) the Characters Per
Inch commands that are sent by the host data stream. You can set Characters Per
Inch to:
Disabled
(Default) The printer accepts and processes commands received from the host data
stream, for Characters Per Inch selection.
Enabled The printer ignores commands received from the host data stream, for
Characters Per Inch. The printer will use the Characters Per Inch value set in
the printer configuration.
To change or check the Characters Per Inch setting:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Override Host
5. Press ENTER, and the printer displays
6. Press SCROLL/MICRO or SCROLL/MICRO until the printer plays
Override Host
Characters Per Inch
7. Press ENTER to display the current value.
8. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Characters Per Inch is displayed.
9. Press ENTER to display the current value.
An asterisk (*) is displayed in front of the selected value.
10. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Chapter 7. ASCII Configuration 83