Compuprint 4247-X03 - Manual (Page 129)

Jam Sensors
You can set Jam Sensors to either of the following values:
Enabled (Default) Enables the paper jam sensors on the front and
rear tractors. This setting alerts the operator with
an 002 FORMS JAMMED FRONT or 020 FORMS JAMMED
REAR
message on the operator panel when a
jammed form is detected in one of the paper paths.
Disabled Disables the paper jam sensors. We recommend
that these sensors not be disabled.
To change or check the Jam Sensors category:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Setup
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Setup
Jam Sensors
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for jam
sensors is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Chapter 8. Printer setup 113