Autofeed-xt, Serial interface, Interface type – Compuprint 4247-X03 User Manual
Page 104: Serial interface interface type

AutoFeed-XT
This parameter is valid in Epson-FX emulation mode only and instructs the printer
whether the host will determine if an automatic line feed is performed after a
carriage return.
You can set this value to:
Disabled
(Default)
The function is determined by the setting of Printer Compatibility 3 –
Automatic Line Feed on Carriage Return.
Enabled
The host determines whether an automatic line feed is performed after a
carriage return.
To change or check the AutoFeed-XT setting, follow these steps:
1.
Press MENU.
2.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3.
Press ENTER.
4.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Parallel Interface
5.
Press ENTER.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Parallel Interface
AutoFeed-XT
7.
Press ENTER to display the current value.
8.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
AutoFeed XT is displayed.
9.
Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
10.
Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Serial interface
Interface type
This parameter allows you to select the Serial Interface attachment type. You can
set Interface Type to:
v
RS-232C
(Default)
To change or check the Interface Type:
1.
Press MENU.
2.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
88
User’s Guide