Code CR1200 - Manual (Page 36)

C003525_06_CR1200_User_Manual 31
Save Settings
7.1 - Reset Reader to Factory Defaults
Scan the following codes to reset reader:
Reset to USB Factory Reset to PS/2 Factory Reset to RS232 Factory
Default Settings Default Settings Default Settings
Note: If you read this Code you will lose any unsaved
settings. Make sure to save the settings on your
reader before reading the codes.
Repairs and Adjustments—Only those individuals authorized by Code should attempt to make repairs or
adjustments to CR1200 equipment. If the reader casing is opened the warranty is voided.
Power Supply—Use only the power supply provided for use with each specific unit when operating Code
equipment.
Accessories—Only those accessories approved by Code should be utilized with Code equipment.
Non-compliance with any of the above may result in:
• Injury to individuals handling the equipment;
• Damage to the equipment; or
• Voiding of the maintenance contract.
7.2 - General Safety Information
Save Settings
Clear All CodeXML Rules
Prefix & Suffix