3 - mirror decoding, 4 - adding prefix settings – Code CR1200 User Manual
Page 33
C003525_06_CR1200_User_Manual
28
Save Settings
50
Most Accurate
75
100
125
1600 (Default)
150
200
400
Least Accurate
6.4.1 - Prefix Settings
If you scan the following codes, you will lose any unsaved settings. Make sure to save settings on your reader
before scanning the prefix codes. If you scan more than one prefix you will receive each scanned prefix in your
scanned data; (i.e., if you scan comma prefix twice, you will get two comma prefixes). Scan the following codes to set
appropriate prefix:
Prefix - Comma
Prefix - Space
Prefix - Tab (USB Keyboard Mode)
Prefix - Tab (RS-232) Prefix - Erase
Prefix - Carriage Return Line Feed
(RS-232)
Note: If you require a special configuration, please contact Code at (801) 495-2200.
Use only with
keyboard
applications
Use only with
serial applications
Use only with
serial applications
6.3 - Mirror Decoding
Scan the following codes to enable/disable the mirroring feature:
Mirroring On
Mirroring Off (Default)
Note: The Mirroring feature allows the CR1200 to read codes as they are seen through a mirror (inversed 180°). If the
Mirroring feature is enabled, non-mirrored reading ability will be disabled.
6.4 - Adding Prefix Settings
Some applications may require specific characters be present at the front or back of decode packets sent to the host.
The Add Prefix and Add Suffix options allow you to add the characters required by the host application.