Cloud Electronics 46-120TMedia - Manual (Page 9)

46-120 Installation and User Guide V1.2 9
Amplifier’s priority circuitry; when enabled, a microphone
signal, post level control, from the LM
-2 will reduce the music
level in the zone where it is installed. Changing a rear jumper
alters the priority operation so that the mixed mic and line
signals from the module cause the mixer’s line input selected
to the Zone to be fully muted.
The module also includes the functions of the RSL-6 Remote
Control Plate (see below), permitting control of zone music
level and source. See page 15 and page 26 for more
information.
The LM-2 connects to the 46-120’s
ZONE 1 FACILITY
PORT via screened Cat 5 cable, and the remote sources are
routed to Zone 1. The mixer’s Mic inputs remain available.
Multiple LM-2s in Zone 1 may be daisy-chained to provide
mic inputs in more than one position in the zone. The LM-2
is available in sizes to suit UK, US and German electrical back
boxes; a choice of finishes is also available.
RL-1 Series
4
5
6
1
2
3 7
9
10 0
8
MUSIC LEVEL
RL-1
The RL-1 Series is a range of small plates with a single control
for locally adjusting the music level in a zone. They connect to
one of the 46-120’s
REMOTE SOURCE + LEVEL ports.
See page 18 and page 26 for more information. RL-1s are
available in sizes to suit UK, US and German electrical back
boxes; a choice of finishes is also available.
RSL-6 Series
RSL 6 -
1
2
3
4
5
6
MUSIC LEVEL
SOURCE SELECT
4
5
6
1
2
3 7
9
10 0
8
The RSL-6 Series is a range of plates allowing local (per-zone)
music source selection as well as music level control. They are
the same size as the RL-1s, and connect in a similar way. See
page 18 and page 26 for more information. RSL-6s are
available in sizes to suit UK, US and German electrical back
boxes; a choice of finishes is also available.
PM Series paging microphones
Cloud PM Series paging microphones (except the PM1 –
see below) may be connected directly to the 46-120 in
two ways: i) via the
CDPM/PM INPUT on the CDI-46
digital interface card (if fitted); or ii) using MIC 1 input and
ACCESS CONTACTS port. Models are available which
can page to 4, 8, 12 or 16 zones, and also to 4 or 8 zones with
storage for built-in spot announcements. As the 46-120 only
supports four zones, not all zones on the “higher” models can
be accommodated by a single 46-120; the PM4 and PM4-SA
(4-zone) models are most likely to be useful. See page 16
for more information.
The Cloud PM1 paging microphone is also compatible with
the 46-120. It is a much simpler unit which addresses a single
zone (though zones may be paralleled for wider access). See
page 17 for more information.