Caple C670 - Manual (Page 7)

7
Fastening the
appliances
Each appliance is supplied with a set
of tabs and screws to fasten it on
units.
– Cut the unit (as shown in the figure
on the previous page).
– Stretch gasket “D” over the edge of
the hole made being careful to
overlay the junction edges.
– Turn the appliance over and put
tabs “A” into the mountings; only
tighten screws “B” a few turns.
Make sure that the tabs are
mounted correctly as shown in the
figures at the side. Turn the tabs so
that the appliance can be put into
the hole.
– Put the cooktop into the hole cut
into the unit and position it correctly.
– Put tabs “A” into place, tooth “C" of
the tabs should go into the hole.
– Tighten screws “B” until the
appliance is completely secured.
– Using a sharp tool cut off the part of
gasket “D” which protrudes from the
cooktop.
A
A
A
A
Fig. 7
Fig. 8
3 cm
min
3 cm 4 cm
B
D
A
C