Caple C670 - Manual (Page 3)

3
Electrical Installation
– The appliance must be connected to
the mains by a competent electrician
and according to the regulations in
force.
– The appliance must be connected to
the mains checking first of all that
the voltage corresponds to the value
given on the rating plate and that
the section of the electrical cables
can take the load indicated on the
rating plate.
– Fit a standard plug which is suitable
for the power absorbed by the
appliance and in conformity with the
local rules in force.
– The plug must be put into a socket
connected to the earth system in
compliance with safety rules.
– For the United Kingdom:
As the colours of the wire of the
supply cable of this appliance may
not correspond with the colours
which identify the terminals of your
plug, proceed as follows:
– the yellow/green wire must be
connected to the plug terminal
marked with the letter E or with
the earth symbol or coloured
green or yellow/green;
– the blue wire must be connected
to the terminal marked with the
letter N or coloured black;
– the brown wire must be connected
to the terminal marked with the
letter L or coloured red;
Installation Requirements
IMPORTANT: Install the appliances
following the manufacturer's
instructions.
Incorrect installation can cause
damage to people, animals or
things, for which the manufacturer
cannot be held responsible.
– The connection can be made
directly to the mains by putting an
all-pole switch with minimum
opening between the contacts of 3
mm between the appliance and the
mains.
– The supply cable must not touch hot
parts and must be so positioned
that it does not exceed the
temperature of 75°C at any point.
– When the appliance is installed the
switch or socket must always be
accessible.
– The appliance must have its own
supply; any other appliances
installed near it must be supplied
separately.
– N.B. For connection to the mains
do not use adapters reductions or
shunts because these can cause
overheating or burning.
If the installation requires modifications
to the domestic electrical system or if
the socket and the appliance plug are
not compatible, contact a professional
electrician.
He must, in particular, also make sure
that the section of the socket cables is
suitable for the power absorbed by the
appliance.
The appliance must be connected to
the earth.
The manufacturer declines all
responsibility for any problem
caused by failure to observe this
instruction.