Cadac S-Type - Manual (Page 68)

GLOSSARY-IV
S-Type Revision S2005-6
electronically balanced output An electronic amplifier stage that produces two
identical output signals, except that one output
signal has the opposite polarity to the other.
EMC Electro-magnetic compatibility. A series of regu-
lations imposed by member countries of the
European Union on manufacturers of electrical
and electronic equipment, to control electro-
magnetic emissions and susceptibility. The par-
ticular standard for audio equipment and sys-
tems is: EN55103-1 (emissions) and EN 55103-
2 (immunity).
EQ PRE INS Input channel feature allowing the equalizer to
be put in circuit before the Channel Insert.
equalizer Input channel stage allowing the frequency
response to be altered within ±18dB at four dif-
ferent frequencies.
EXT I/P A connector allowing an external signal to be
plugged into the Oscillator module.
external relay switched equipment See Event above.
fader display Alphanumeric display on the DC Master faders
showing the allocated number for each DC Mas-
ter.
fader panel Located below the input/output channel mod-
ules, the fader panel contains the fader itself and
LEDs for indicating DC or MG assignment. It
also has buttons for MUTE, Bypass, SET, Iso-
late and input level bargraph meter.
fader tray
Area of the console surface that accommodates
the fader modules.
FoH Abbreviation of Front-of-House. Refers to the
location/configuration of a console in a produc-
tion setup.
frame The part of the console that holds modules and
fader panels.
full L-C-R panning Panning mode that allows the signal from an
input channel or output group to be positioned
between left, centre or right outputs.
Global listen All channels set to Listen mode.
global PFL All channels set to PFL mode.
group Module where signals are mixed together from
appropriately assigned input channels.
HF High Frequency control located in the EQ-sec-
tion of each input channel.
high-pass filter Filter that cuts off undesired low frequencies.
HMF Higher Mid-Frequency control located in the EQ-
section of each input channel.
HOLD Applies to the PFL/Listen feature. If HOLD is
OFF, any new selected PFL or Listen signal will
cancel the previous one (intercancel function).
When HOLD is ON, it is possible to mix the new
signal with the previous one if any of the buttons
PFL or Listen is pressed on another module.