Cadac S-Type - Manual (Page 31)

Stereo input module 8412 5-3
Revision S2005-6 S-Type
81419 35(#0#3UH#IDGHU
Press this button to route the pre-fader signal to Direct Output. If INPUT or PRE are
not selected the Direct Output is sourced post fader.
8141: 'LUHFW#RXWSXW#OHYHO#FRQWURO
Use this rotary control to adjust the direct output level. Level control is from infinity to
0dB.
8141; 6XE0JURXS#URXWLQJ
The sub-group routing buttons allow post fader signal to be routed to the sub-groups,
with optional pan information, see 5.1.11. To route a signal from an input channel to
a sub-group, press the relevant numerical button on the sub-group.
5RXWLQJ#WR#PDWUL[#RXWSXW
Before you can route a signal to the matrix outputs, the signal has to be routed to one
of the sub-groups (see 5.1.8). The signal can then be routed to the matrix sends by
using the appropriate controls on the 8413 & 8415 modules.
8141< 67#0#6WHUHR
Pressing this button routes a post pan and fader signal to the Stereo master. The
PAN potentiometer will affect this signal regardless of whether the pan button is
pressed, see 5.1.11.
814143 3$1
Press this button to enable panning of the sub-groups via the PAN potentiometer.
814144 3$1#FRQWURO
Use this rotary control to pan the signal within the stereo field.