Cadac S-Type - Manual (Page 64)

SPEC-II Technical specifications
S-Type Revision S2005-6
1RLVH#ILJXUH
Microphone, 10dB gain, with fader set to 0dB.
<-93dBu 200 Ohms, 10dB gain
<-69dBu 200 ohms, 60dB gain
MIc input to:
Matrix <-93dBu
Sub group <-93dBu
Mono Aux outputs <-93dBu
Stereo Aux outputs <-91dBu
Residual noise:
Matrix <-100dBu
Sub group <-99dBu
Aux outputs <-100dBu
&URVVWDON
0dBu input level, total gain = 20dB
Adjacent channels -89dBu (noise on input) at 1kHz
-89dBu (noise on input) at 20kHz
Adjacent sub outputs -110dBu at 1kHz
-86dBu at 20kHz
Adjacent matrix o/p’s -117dBu at 1kHz
-87dBu at 20kHz
Adjacent aux outputs -88dBu at 1kHz
-65dBu at 20kHz
Channel mute isolation -115dBu at 1kHz
-96dBu at 20kHz
Channel fader isolation -106dBu at 1kHz
-92dBu at 20kHz
,QSXW22XWSXW#FDSDELOLW\
Maximum input level +11dBu at minimum gain
+31dBu with -20dB pad
Maximum output level +22dBu into 2kOhms
3KDVH#UHVSRQVH#+GHJUHHV,
Mic input to sub group/matrix/aux output, EQ - in and flat
20Hz 100Hz
Sub 4.9 ž 0.84 ž
Aux 4.7
ž
0.85
ž
Direct output 2.9 ž 0.57 ž
&RPPRQ#PRGH#UHMHFWLRQ#UDWLR#+G%,
Electronically balanced mic input to direct output.
20Hz 100 1k 10k 20k
20dB gain 65 85 85 60 55
NOTE: 0dBu = 0.775V r.m.s. without reference to impedance. Unless stated
otherwise, all specifications apply to the frequency range 20Hz-20kHz. All
noise measurements are r.m.s. via a DIN audio band filter, with -3dB points at
22Hz and 22kHz.