21 hf eq cut/boost & frequency control 1k5hz-15khz, 22 hf q-control, 24 hmf q-control – Cadac S-Type User Manual
Page 24: 26 lmf q-control, 28 lf q-control

4-6
Mono input module 8411
S-Type
Revision S2005-6
714154 +)#(4#&XW2%RRVW#)#)UHTXHQF\#FRQWURO#4N8+]048N+]
This dual concentric potentiometer allows the centre frequency to be adjusted
between 1k5Hz and 15kHz (lower control) and the gain to be adjusted by ±18dB
(upper control). The gain control is centre detented.
714155 +)#40FRQWURO
The Q-control varies the bandwidth of the selected frequency selected as per 4.1.21.
As indicated on the front panel when turned towards the low ‘Q’ symbol (Q approxi-
mately 1.0) will cause a wide bandwidth of frequencies to be affected around the
selected centre frequency. When set towards the high ‘Q’ symbol (‘Q’ approximately
3.0) a narrow band of frequencies will be affected around the centre frequency.
714156 +0)#(4#&XW2%RRVW#)#)UHTXHQF\#FRQWURO#733+]#0#7N+]
This dual concentric potentiometer allows the centre frequency to be adjusted
between 400Hz and 4kHz (lower control) and the gain to be adjusted by ±18dB
(upper control). The gain control is centre detented.
714157 +0)#40FRQWURO
The Q-control varies the bandwidth of the selected frequency selected as per 4.1.23.
The function of the Q-control is described in 4.1.22.
714158 /0)#(4#&XW2%RRVW#)#)UHTXHQF\#FRQWURO#93+]#0#933+]
This dual concentric potentiometer allows the centre frequency to be adjusted
between 60Hz and 600Hz (lower control) and the gain to be adjusted by ±18dB
(upper control). The gain control is centre detented.
714159 /0)#40FRQWURO
The Q-control varies the bandwidth of the cut/boost frequency selected as per
4.1.25. The function of the Q-control is described in 4.1 22.
71415: /)#(4#&XW2%RRVW#)#)UHTXHQF\#FRQWURO#53+]#0#533+]
This dual concentric potentiometer allows the centre frequency to be adjusted
between 20Hz and 200Hz (lower control) and the gain to be adjusted by ±18dB
(upper control). The gain control is centre detented.
71415; /)#40FRQWURO
The Q-control varies the bandwidth of the cut/boost frequency selected as per
4.1.27. The function of the Q-control is described in 4.1.22.