Bompani BO263EB/E - Manual (Page 21)

21
screw until the fl ame is at the minimum level
but does not go out; the fl ame must remain
stable even in light draughts;
- replace the knob.
CONNECTING TO THE ELECTRICAL
MAINS
Before making the connection, check that:
- the mains voltage is as indicated on the
nameplate;
- the earth connection is in good working
order.
For direct connection to a power mains, a
device that ensures disconnection from the
mains must be installed, with a opening
distance for the contacts that allows for a
complete disconnection under conditions of
category III electrical overload, in conformity
with the installation instructions.
If the appliance power lead is not fi tted with
a plug, use an approved standard type, re-
membering that:
- the green-yellow wire must be used for the
earth connection;
- the blue wire is the neutral;
- the brown wire is live;
- the lead must never touch hot surfaces over
about 75 degrees C;
- in case of replacement, the power lead
must be of type H05RR-F or H05V2V2-F
of adequate gauge (see fi g.2) for gas and
all-electric appliances, and type FR 3 R3 of
adequate gauge (see fi g.2) for gas-electric
appliances;
- the power supply lead must only be repla-
ced by a qualifi ed electrician.
IMPORTANT: the manufacturer declines all
liability for damage due to failure to comply
with the regulations and standards in force.
Check that the appliance is correctly con-
nected to the earth (see diagrams in fi g. 2
at the back of the manual).
FOR HOBS WITH ELECTRIC IGNITION
The correct gap between the electrode and
the burner is shown in fi gure 12.
If no spark is generated, do not keep on trying
as this might damage the generator.
Possible causes of malfunctions:
- spark plug damp, dirty or broken;
- electrode-burner gap not correct;
- spark plug wire broken or without shea-
thing;
- spark discharging to earth (to other parts
of the hob);
- generator or microswitch damaged;
- air has built up in the pipes (particularly
if the hob has been out of use for a long
time);
- air-gas mixture incorrect (poor fuel set-
ting).
THE SAFETY DEVICE
The correct gap between the end of the ther-
mocouple sensor and the burner is shown
in fi gure 12.
To check that the valve is working properly,
proceed as follows:
- ignite the burner and leave it to work for
about 3 minutes;
- turn off the burner by returning the knob to
off position ( );
- after 90 seconds turn the knob pointer to
the “open” position;
- release the knob in this position and move
a burning match towards the burner; IT
MUST NOT IGNITE.
Time needed to excite the magnet during
ignition: 10 seconds approx.
Automatic tripping time, after fl ame has been
turned off: not more than 90 seconds.
IMPORTANT:
- The electrical plug must be disconnected
and the gas tap turned off before any tech-
nical work inside the appliance.
- Never use matches to check the gas circuit
for leaks. If a specifi c control device is not
available, foam or very soapy water can be
used.
- When re-closing the hob, check that the
electrical wires of the spark plugs (if pre-
sent) are not close to the injectors, so that
they cannot run across them.
Installation GB