Bompani BO263EB/E - Manual (Page 19)

19
ELECTRIC HOTPLATES
ø 145 mm 1,0 kW - Normal hotplate
1,5 kW - Rapid hotplate
ø 180 mm 1,5 kW - Normal hotplate
2,0 kW - Rapid hotplate
Cat.: see nameplate on cover; Class 3
Type “Y” built-in hob
EQUIPMENT
Depending on the models, hob may also
have:
- Safety device for one or more hob bur-
ners
- Electric ignition on top burners
- One or more electric hotplates
For the LAYOUT OF HOB BURNERS OR
ELECTRIC HOTPLATES see the models
illustrated in figure 1 at the back of this
manual.
For the ELECTRIC WIRING DIAGRAM see
fi gure 2 at the back of this manual.The electri-
cal power is indicated on the nameplate
underneath the hob.A copy of the nameplate
is glued to the cover of this manual.
INSTALLATION
The appliance must be installed by quali-
fi ed staff working in accordance with the
regulations in force.Before installing, ensure
that the appliance is correctly preset for the
local distribution conditions (gas type and
pressure).The presettings of this appliance
are indicated on the nameplate shown on
the cover.This appliance is not connected
to a fl ue gas extractor device. It must be
installed and connected in accordance with
the regulations in force.This appliance may
only be installed and may only operate in
rooms permanently ventilated in accordance
with national regulations in force.
VENTILATION
The rooms in which gas appliances are in-
stalled must be well ventilated in order to al-
low correct gas combustion and ventilation.
The air fl ow necessary for combustion is at
least 2 m
3 /h for each kW of rated power.
POSITIONING (Fig. 3)
Free the hob from the packaging accesso-
ries, including the fi lms covering the chrome
plated or stainless steel parts. Place the
hob well away from items of furniture taller
than the hob for built-in installation. Must be
installed a partition parallel to the hob must
be at least 1 cm lower than the box unit in
which it is installed, and a square opening
with sides of 10 cm must be made under the
gas hose elbow. You are advised to make
the gas connection before fi tting the hob into
the supporting unit.
FIXING
A self-adhesive seal (A) is supplied with the
hob. This must be placed under the edge of
the box unit, as close as possible to the edge
itself (fi g. 4). The seal must run all round the
unit to ensure a perfect seal and prevent
moisture from seeping under the hob.Under
the galvanized support there are 2 rectangu-
lar openings to take the fi xing brackets (fi g.
5).If the work top is 4 cm thick, the brackets
must be positioned as shown in fi g. 6 (with
GAS BURNERS CHARACTERISTICS
Technical data GB Installation
Gas Burner Injector Consumption Low fl ow-rate
(kW)
Nominal fl ow-rate
(kW)
G20
20 mbar auxiliary
rapid 76
128 95 l/h
276 l/h
0,45
0,95 1,00
2,90
G30 / G31
28-30 / 37 mbar auxiliary
rapid 50
85 73 g/h
211 g/h
0,45
0,95 1,00
2,90