Programming – Beisler 2112-4 User Manual
Page 77
- D 77 -
Short Seam Automat 2112-4 Working Instructions
Beisler Automated Sewing Equipment
D.3
Programming
D.3.1 System menu
Move clamp by hand. If the numeric value (mm) changes,
the sensor is operational.
•
Press
key exit menu.
Setting clamp travel steps
Switch machine on and allow to reference (perform RE-
SET) (see also Service Instructions).
•
Press
key.
•
Press
key (diagnostics).
•
Press
% key.
•
Press
key (clamp transport).
•
Press
% key.
•
Press
key (clamp motor steps).
•
Press
% key.
Set travel steps using reference switch SO4:
•
at switch 735 mm
•
right stop 00 mm
Displaying total piece counter:
With this counter, the total number of finished pieces can
be displayed. The counter cannot be reset.
•
Press
key.
•
Press
key (additional programs).
•
Press
key (piece counter).
•
Press
key exit menu.
The number of pieces : 0000000 is displayed.
Eprom seam parameters:
This function allows to copy the factory-programmed fi-
xed seams from the Eprom back to the sewing program.
•
Press
key.
•
Press
key (init parameters).
•
Press
key (Eprom seam parameters).
•
Enter seam number using numeric keypad.