Beisler 2112-4 - Manual (Page 63)

- C 63 -
Short Seam Automat 2112-4 Working Instructions Beisler Automated Sewing Equipment
C.5
Maintenance
C.5.5 Machine set-up
Setting the thread cutter:
The three-digit value input (GP Par. 35) determines when
the thread cutter is activated.
The setting of the thread cutter must be checked during
machine operation and corrected as required.
1. Rotate sewing head handwheel in direction of machine
rotation until needle reaches highest point (pinning po-
sition C).
Lock handwheel at position C by depressing pinning
pin of hole to left of handwheel.
2. Abb. 25: Install drive belt
1 so that the shaft feather
key
2 is flush with motor housing mark 3.
3. Unlock handwheel.
4. Call menu Global Parameters:
• Press
key
• Press GP key
Insert the following values in Global Parameters:
35: Thread lever in position up
200 INC
36: Switch-on pos. for thread cutting 110 INC
Store value and exit setting level:
• Press key
5. Start the thread cutting function:
• Press key
• Press
diagnostics key
• Press
sewing motor key
Fig. 25
Fig. 25
• Press
thread cutter key
Start or stop machine run:
• Press
key
6. Check position C to see if shaft feather key
2 is flush
with motor housing mark
3.
If required, change values and test thread cutting func-
tion.
7. Start thread cutting and recheck positions.