BayTech ATS Power Switching units 2012 - Manual (Page 12)

Page
12
HELP OPTIONS
Menu 1: Help
Configuration Menu
To select the configuration menu, type ‘Config” at the prompt. Left screen shot older units, Right screen shot
2010 firmware
Manage User
Add a User
ATS> help
Status --ATS-11 Status
Config --Enter configuration mode
Current --Display True RMS Current
Voltage --Display True RMS Voltage
Clear --Reset the maximum detected current
Temp --Read current temperature
Logout --Logoff
Logoff --Logoff
Exit --Logoff
Password --Changes the current user password
Whoami --Displays the current user name
Unitid --Displays the unit ID
Type Help for list of commands
ATS>
ATS11/12>config
1)...Manage Users
2)...Change Outlet Name
3)...Enable/Disable Status Menu
4)...Change Unit ID
5)...Change Alarm Threshold
6)...Change ATS Switching Voltage Points
7)...Change ATS Switch Back mode/time
8)...Change ATS Delay Switch to secondary
X)...Exit
Select 1), from the configure menu to allow the
admin user to add and delete users, change
passwords, and change the outlet list. The following
menu appears if the unit has been reset or initial
setup: ----------------------
| User | |
----------------------
----------------------
A)...Add User
D)...Delete User
R)...Rename User
Enter user number to assign Outlets, A, D or R.
Enter Request:
NOTE: If the “Add user” option is NOT
present than the maximum number of users
have been assigned. You will get a message
saying „No more users can be added’. NOTE: the first assigned user will be the
“admin user” for the outlet. Older units
will not display the “delete” option until a
user is added.
ATS11>config
Unit ID: ATS11
1)...Manage Users
2)...Enable/Disable Status Menu
3)...Change Unit ID
4)...Change Alarm Threshold
X)...Exit
Enter Request: