BayTech ATS Power Switching units 2012 - Manual (Page 11)

Page
11
Detail Operations and Configurations
ATS Series
(C) 2010 BayTech
F1.00
Option(s) Installed:
True RMS Current
Internal Temperature
True RMS Voltage
Enter user name:
Enter Password:
ATS Series
(C)2010 Baytech
F1.00
Option(s) Installed:
True RMS Current
Internal Temperature
True RMS Voltage
Primary Source 1
Source 2: 121.2 Volts
------------------------------------------------------------------------------
| Power | True RMS | Peak RMS | True RMS | Average | Volt- |
| Source | Current | Current | Voltage | Power | Amps |
------------------------------------------------------------------------------
| Source 1 | 0.1 Amps | 0.2 Amps | 121.7 Volts | 0 Watts | 21 VA |
------------------------------------------------------------------------------
Internal Temperature: 24.0 C
1)...Outlet 1
2)...Outlet 2
3)...Outlet 3 4)...Outlet 4
5)...Outlet 5 6)...Outlet 6
7)...Outlet 7 8)...Outlet 8
9)...Outlet 9 10)...Outlet 10
11)...Outlet 11 12)...Outlet 12
Type "Help" for a list of commands
ATS>
The Status Menu will display after the user logs in (if a login is required). This menu lists the firmware
version, installed options, primary source, secondary source voltage, primary source current, voltage, and
power, and the internal temperature of the ATS unit.
If there are users installed on the unit a login
will be required. This may have a password or
not. It is recommended that at least two users be
entered. The first user will be the Administrator
and will be able to manipulate the unit. This
user should be password protected. The second
user can be labeled “Guest” and need not be
protected. Both should be given access to the
outlet(s)
NOTE: Int. Temp = unit internal temperature reads in Fahrenheit or Celsius.
Type “help” at the prompt to display a list of commands to change the outlet state, outlet
configuration, and internal sensor measurements.