Basler Electric BE1-25 - Manual (Page 58)

Figure 5-1. Maximum Slip Frequency versus Time Delay and Phase Angle Settings
Condition and Mode Switches
Detailed instructions and precautions for programming the Mode switches and Condition switches are
provided in Table 2-1, callouts R and S. The location of the switches is shown in Figure 2-2.
When output contacts of both Sync and Voltage Monitor functions are wired in parallel, the live line/live
bus Condition Switch No. 2 must be in OFF position. Otherwise, the Sync function will be overruled. If the
condition switches are external (option 2-C, 2-U, or 2-V), the external LL-LB switch should be omitted
when Sync and Voltage Monitor contacts are in parallel.
5-2 BE1-25 Testing 9170200990 Rev U