Avery Dennison Monarch 926 Knife - Manual (Page 4)

4
If using a 9855 printer, adjust the cut position from the printer’s keypad as
shown:
To change the setting, from the Main Menu, select Setup, Supply, then
Positioning. Then, follow these steps.
1. Press  or  until you see
POSITIONING
 Cut Pos 
2. Press Enter/Pause. You will see the current setting, for example:
Enter knife adj
[-300/300]: +0
3. Press  or  to change the cut position. Pressing  decreases the
value (moves the cut down);  increases it (moves the cut up). The cut
position adjusts where the tag is cut. The printer adjusts the cut
position according to the black marks on the supply. You may need to
adjust for aperture supplies.
Note: We do not recommend setting a positive cut position while using
extended backfeed. You may cut off the leading edge of the next
tag.
4. Press Enter/Pause when the number you need appears. Press
Escape/Clear to exit to the Setup menu.
To adjust the cut type or cut multiple, your System Administrator should
send the Batch Control Field.
Defining the Batch Control Field
The batch header must precede this field. The batch control field defines
the print job and applies only to the batch that immediately follows.
Syntax E,feed_mode,batch_sep,print_mult,multi_part,
cut_type,cut_mult¦
E1. E Batch Control Field.
E2. feed_mode Feed Mode. Options:
0 Continuous Feed (default)
1 On-demand