Avery Dennison Sierra Sport4 9493 Vehicle Mount User Manual
Page 2
2
C o n n e c t i n g C o m m u n i c a t i o n s C a b l e s
The printer uses either 9-pin serial
communications or USB communications. For best
results, use only Monarch® cables. Refer to the
Operator’s Handbook for more cable information.
1. Open the hinged cable door on the side of the
printer by loosening the two screws with a
Phillips screwdriver.
2. Plug the DB9 connector into the DB9 serial
port,
or plug the type A or mini-B USB connector
into the appropriate USB port.
3. Place the cable in one of the cable cavities.
4. Close the cable door and tighten the screws.
I n s t a l l i n g t h e M o u n t
Only qualified personnel should install the vehicle
mount, using one of the three supported mounting
positions shown in these instructions. The mount
is 9.5 inches (240 mm) wide and 7.5 inches (187.5
mm) long.
Following is a list of the mounting hardware
included with the vehicle mount:
four M6 x 60 2 3/8-inch screws
(3/16-inch hex)
four lock washers
one mounting plate
two aluminum strap
buttons
one M3 allen wrench
O ve r h e a d vi e w o f m o u n t s h o w i n g
l o c a t i o n a n d s p a c i n g o f m o u n t i n g
h o l e s .
70.0 mm
50.80 mm