Avery Dennison Sierra Sport4 9493 Vehicle Mount User Manual
Page 11
11
4. Align the holes in the supply holder with the
posts on the mounting plate. The supply holder
goes on the “outside” of the vehicle mount.
5. Replace the four lock washers and nuts to
fasten the supply holder in place.
6. Attach the printer. See “Attaching the Printer”
for more information.
Loading Supply on the External Supply
Holder
The external supply holder can hold up to a 5-inch
(127 mm) maximum outer-diameter supply roll.
To load supply on the supply holder:
1. Open the supply holder. Unscrew the knob on
the side of the holder and pull it open.
2. Remove the tape from a new roll of supply.
3. Insert the supply roll onto the supply holder so
it unrolls from the bottom.
4. Close the side of the holder and tighten the
knob.
5. Load supply in fan-fold mode. Refer to the
printer’s documentation for more information.