Avery Dennison Full Size Sensor - Manual (Page 7)

Service Manual Full Size Sensor
11/07
Rev. 1.03 7
Assemble Option
Change position of pressure lever
The lever position has to be changed from its normal position to a
position rotated 90 degrees (see photo).
Open the lock washer, push back the axle – remove the lever from the
axle – rotated the lever (90 degree) and pull the lever back to the axle.
Move the axle back into the hole of the metal plate and lock it with the
washer.
Remove media guiding
The old media guiding has to be removed from the unit. Therefore loosen the two
axles (locked with bushes) – open as well the hexagonal screws of the guiding (if
there) – and remove the axles to the front of the steel plate.
Attention: The inner guiding (with the sensor) will be used again – the outer
guiding can be thrown away . The new one (delivered with the sensor)
will be used.
pressure lever
lock washer
axle