Avery Dennison Full Size Sensor - Manual (Page 6)

Service Manual Full Size Sensor
11/07
Rev. 1.03 6
Media limitation
Please watch carefully, that the full size sensor can only be used with cardboard material
(notched) ! The sensor is a digital sensor – means only 0 and 1 – self adhesive media can
not be used.
The
minimum media width – used with the full size sensor – has to be 36 mm ! If the full size
sensor is mounted to the unit – as well the standard sensor can not be used for smaller
material.
The optional full size sensor can be moved from
Printer can be moved from - to (mm)
TTX 450 16 – 93
TTX 650 16 – 134
TTX 950 16 – 165
Unpack
Normally the full size sensor is supplied mounted to the printer (installed) ! If this is not the
case – the option can be retrofitted by a service technician !
Attention: To activate the sensor please follow the instruction shown in chapter set up
mode.
Please check if all parts are delivered
2
additional axle
1 outer side plate
1 inner side plate
1 steal part inner
1 sensor assy. ( 2 parts – 1 cable)
1 outer media guiding