Avery Dennison 9460IP Setup Guide - Manual (Page 9)

9
Setting the ESS ID
1. From the Configure menu, select ESS ID.
ESS ID
ABC 1234
E R D
Use the A buttons as shown in the following table:
E
Press A to R
Press A to +
Press A to
Saves the setting Scrolls through the positions
from left to right Increments the current
position setting by 1 and
scrolls through
alpha/special characters
2. When the setting you want is displayed, press the A button under the E
icon to save the setting.
3. Press the F button to exit.
When you select “Exit” after configuring, you will see
Configure
Re-configure?
E X
To save all the configuration settings, press the A button under the E icon.
To exit without saving the configuration settings, press the A button under
the X icon.
The IP printer is ready to use. Turn on the printer.
When you see
Ready
p
Press the A button under the connected icon to see the printer’s IP
Address. Press any A button to toggle back to Ready.