Avery Dennison 9414 Dough Memo - Manual (Page 3)

A status bar is displayed on the PC showing each of the files (two) as they load.
A successful update shows in the lower, left-corner of the screen.
6. Follow the on-screen prompts to connect the printer to the Keypad.
The Keypad is now updated.
7. Remove the CD from the CD-ROM drive and return it to the kit’s box.
8. Click OK to clear the prompt message, and then click Exit to close the Pizza Hut Update
Utility.
9. Unplug the Keypad’s power source from the electric wall outlet.
10. Unplug the null-modem serial cable number 125801 from the Keypad (if still connected) and
reconnect the printer’s cable.
11. Continue with Step 4 (Apply the new Keypad Label).
If Your PC Does Not Have a Serial Connection/Port:
1. Buy a USB to Serial converter.
2. Plug in the USB to serial converter BEFORE turning on the PC, so the system sees the USB
port as it boots. You must insert the USB Driver CD into the CD-ROM drive on the PC to
install the driver. The USB Driver CD came with the USB to serial converter.
3. Insert the Pizza Hut Update Utility CD into the CD-ROM drive on the PC. The CD should
automatically start the installation process. Follow the on-screens prompts as necessary.
After the Pizza Hut Update Utility software is loaded:
NOTE: Make sure the Keypad is connected to the PC using the USB to serial converter and the
cable 125801 that came with this kit. Do Not Interrupt This Process.
4. Click the Windows Start button (found in the lower left hand corner of the PC screen).
5. Click Programs, then, click Pizza Hut Update Utility. Click Setup in the upper left corner.
6. Click Com Port in the lower right and highlight what is in the Com Port Setting box.
7. Close the Com Port screen and then click the Update button - this takes approximately 7
minutes.
Check Keypad display to confirm update activity. Characters should be scrolling by on
lower line of display. If not, check cable and power connections and re-try update process
from steps d-e above. A status bar is displayed on the PC showing each of the files (two) as
they load. A successful update shows in the lower, left-corner of the screen.
8. Follow the on-screen prompts to connect the printer to the Keypad. The Keypad is now
updated.
9. Remove the CD from the CD-ROM drive and return it to the kit’s box.
10. Click OK to clear the prompt message, and then click Exit to close the Pizza Hut Update
Utility.
11. Unplug the Keypad’s power source from the electric wall outlet.
12. Unplug the null-modem serial cable number 125801 from the Keypad (if still connected) and
unplug the USB to serial converter.
13. Reconnect the printer’s cable.
14. Continue with Step 4 (Apply the new Keypad Label).
Step 4 Apply the new Keypad Label
1. Clean the Keypad’s top with an alcohol wipe before applying the new label.
2. Remove the backing from one of the new Keypad overlay labels.
3. Carefully place the label over the top of the current Keypad. Line up the label with the gold-
colored border on top of the Keypad.