Avery Dennison 9414 Dough Memo - Manual (Page 2)

E x p r e s s D a t i n g a n d L a b e l i n g A p p l i c a t i o n : U p d a t e I n s t r u c t i o n s
This kit contains the following:
♦ 1 software CD-ROM with the upgrade utility ♦ PC to Keypad cable – (part number 125801)
♦ 2 Keypad labels with updated key layout
♦ Rubber Keypad cover for added protection
♦ Scan sheet (TCEXPSCAN) ♦ Operating manual (TC9414PHX)
♦ Plexiglass Tray and Setup Guide (TC9414PHSG)
NOTE: Keep all of the above contents, because they are necessary if your Keypad needs to be
updated again at a later date.
Step 1 Install Pizza Hut Update Utility to PC
1. Insert the CD into the CD-ROM drive on the PC. The CD should automatically start the
installation process.
2. Follow the on-screen prompts: In any messages that appear on the PC screen, click OK, Next,
or Continue. The new version of the Software is now in the PC and you are ready to update the
Keypad.
Step 2 Connect Keypad to PC
Make Sure the Keypad’s Power Source is Unplugged from Electric Wall Outlet!
Do all of this Step and Step 3 (Update Keypad Application from PC) if your PC has a serial
connection/port. If your PC does not have a serial port, go to “If Your PC Does Not Have a Serial
Connection/Port” instead.
1. Using null-modem serial cable number 125801, connect the 9-pin male end to the Keypad. This
cable comes with this kit. Disconnect the existing cable from the back of the Keypad to connect
the null-modem serial cable.
2. Connect the other end to the PC. If using the TT5 Keypad with the 9-pin male connector,
connect as instructed.
If using the older-style TT5 Keypad with the 25-pin connector, connect the update cable (part
number 120183) to the printer cable (part number 125801) by plugging the 9-pin ends together.
Then, connect the 25-pin end to the Keypad and the 9-pin end to the PC.
If PC port is a 25-pin male, use a 9-pin male to 25-pin female serial adapter. This adapter can
be purchased from the following sources:
♦ Staples – SKU# 657163 – Manufacturer: Belkin
♦ Online at CDW.com – part# 083569 - Manufacturer: Belkin
Step 3 Update Keypad Application from PC
Do Not Interrupt This Process
NOTE: Make sure the Keypad is connected to the PC AND the Keypad is plugged into the electric
wall outlet before continuing.
1. Click the Windows Start button (found in the lower left hand corner of the PC screen).
2. Click Programs.
3. Click Pizza Hut Update Utility.
4. Move cursor to the right and click on the pop up box Pizza Hut Update Utility.
5. Click the Update button – this takes approximately 7 minutes.
Check Keypad display to confirm update activity. Characters should be scrolling by on
lower line of display. If not, check cable and power connections and re-try update process
from steps 1-5 above.