Avery Dennison Monarch 9906 Quick Reference User Manual
Page 7

EN-7
12.
Remove any slack in the ribbon by turning the take-up reel
clockwise.
13.
Hold the printhead assembly by the printhead tab while
pressing down on the printhead release.
14.
Close the printhead by pressing down on the thumb well until
you hear it click into place.
15.
Close the printhead. Close the printer’s cover.
16.
Press FEED.
C l e a n i n g
Clean the printhead as described to maintain printhead life.
Caution: Do
not use sharp objects to clean the printhead or
touch the printhead; this may damage the printhead
and require a service charge.
1.
Turn off the printer, open the cover and the printhead
assembly.
2.
Remove the label roll and ribbon (when cleaning the
printhead).
3.
Press down on the exit cover tabs to open the exit cover.
4.
Spray the supply path, including supply sensor, with
compressed air to remove dust.
5.
Use a CLEAN-STRIP (part number 120350) to clean and
remove adhesive build-up from the platen roller, peel bar,
sensor, and printhead.
6.
Let the printer dry, then reload supplies.
7.
Close the exit cover.
8.
Close the printhead assembly and the printer’s cover.
9.
Turn on the printer. Press FEED.
Platen Roller
Printhead
Sensor
Peel Bar