Avery Dennison Monarch 9860 Programmer Manual Addendum2 - Manual (Page 7)

Example {I,X,0,3,10,10,6¦}
Uses the default protocol (Class 1 Gen 2), sets the number of write attempts
to 3, sets the read and write power to 10 and the signal adjustment to 6.
The test label has been updated to show the settings for the RFID Setup
Packet.
RFID Setup Packet
D e f i n i n g t h e R F I D S e t u p P a c k e t f o r H F ( 9 8 5 5 o n l y )
Use the RFID setup packet (X) to set the protocol, write attempts and
r to the HF Setup Guide and Supply Chart for the protocol and
Syntax ¦}
. Options:
3
X3. write_attem The numb interrogator tries to program the
X4. attenuation nge is
Example
de UTO-Select), sets the number of write attempts
d to show the settings for the RFID Setup
Packet.
attenuation.
Note: Refe
attenuation settings based on your RFID supplies.
{I,X,protocol,write_attem,attenuation
X1. X RFID Setup Packet
otocol col. The default is 0 X2. pr Select the HF proto
0 AUTO-Select
1 TI ISO15693
2 NXP ISO1569
3 I-CODE UID
er of times the
D in the RF Fi RFI tag eld. The range is 1 – 4. The
default is 3.
The amount of power to read an RFID tag. The ra
1 – 4. The default is 2.
{I,X,0,3,2¦}
Uses the fault protocol (A
to 3 and the attenuation to 2.
The test label has been update
7